search

Fred's RCL i4

hashtag
Useful Links

Fred's RCLi4 Octoprintarrow-up-right

hashtag
How to Print

Please refer to the How to Print guide for detailed instructions

hashtag
Slicer Setup

  1. Open Cura LE

  2. Go to Settings > Printers > Add printer

  3. Click Other (see figure 1)

  4. Click "Custom" then "Custom FDM Printer" then click Add Printer (see figure 2)

  5. Click Add Printer

  6. Enter Machine Setting config noted below

    1. Follow the Green Boxes

    2. Printer Tab

      1. Configure Printer (see figure 3.1)

      2. Enter custom start Gcode (see figure 3.2)

      3. Enter custom end Gcode (See figure 3.3)

    3. Hot End Tab

      1. Configure Hotend (see figure 4)

  7. Click Finish

figure 1
Figure 2
Figure 3.1

Custom Start Gcode - Figure 3.2

Custom End Gcode - Figure 3.3

Figure 4
PreviousRobo3dNextCrafting, Textiles & Sewing

Last updated

Was this helpful?